Rybářská samolepka "Jedu na ryby" - ID: 12340 - ORG ID: 2408

Fishing sticker cut from high-quality vinyl (with a lifespan of up to 5 years).

These stickers are suitable for both outdoor and indoor use. They are most commonly used on cars, fishing boxes, etc.

Dimensions: 20 x 7,5 cm

STICKER APPLICATION – INSTRUCTIONS

a) The recommended temperature for application is 15-28°C.

b) The surface where the sticker will be applied must be well-cleaned and degreased (ideally with alcohol, which should be allowed to evaporate).

1. Place the sticker on the desired spot.

2. Use a rubber or felt squeegee to slowly push out any air bubbles (from the center of the sticker towards the edges).

Tip: For curved surfaces and indentations, gently heat the sticker using a hairdryer or heat gun (be very careful not to melt the sticker).

Small stickers (silhouettes) should be applied dry: carefully place them in the desired spot, as they cannot be removed without damage once adhered.

For large stickers, it is recommended to apply them wet: mix water with a bit of dish soap in a spray bottle (use clean water for glass surfaces) – spray both the surface and the sticker before applying – let it dry for 30-60 minutes (depending on the temperature) – if the edges of the sticker start to lift, allow more time for drying and you can carefully warm it with a hairdryer. Heat increases the adhesive's bond to the surface; the vinyl becomes softer and easier to shape – at lower temperatures, the adhesive reacts less effectively with the surface.